How To Do Application of:

Ty-Dye Sets As Seen In Nail Pro Mag.

**When applying the Base Gel Coat after Cleanzing, Priming and Base- Make sure this is a good even flow coat that looks clean and shiny like glass

1 - When ready to apply Colour onto nails Cleanz all nails with Nail Cleanz using a Lint Free Wipe

2 - Choose 2-3 or as many Ty-Dye Colors as your client prefers. You can even mix and match Ty-Dye Colours from different sets.

3 - Apply a thin Flow Coat of Colour Base #1 onto the area where you are wanting to put the Ty-Dye design, I.E. Full Colour, Tip Colour, a Chevron or other Designs you have seen on the Website.

4 - Start by tapping one colour on the nail (not covering the whole nail area with that one colour) leave areas where you can add other colours, and proceed by adding other colours you or your client have chosen. Add liberally to the nail do not be afraid that you are putting too much.

5 - If you see a shiny spot in the nail this means the colour has soaked into the Colour Base and you may add more colour to this area.

6 - Once you have the colours desired on to the nail area, tap the end or the tip of the clients fingernail, the colour will skip or jump across the nail (this is ok)

7 - Next have your client tip there finger upside down (in the gravity pull position) and tap the excess off the nail by tapping on the pad of their finger.

8 - Cure the nails just as normal with any other colour.

9 - Before applying Clear Builder Finish or a Colored Builder Finish take your Nail Brush and dust off any excess Colour from around the Cuticle or the nail.

10 - Apply Builder Finish as normal.

******If you are wanting to apply Stripping Tape or Decals of any type you must apply Base Gel to the top of the finished cured Ty-Dye Colours and cure for a full 4 Minutes then apply Stripping Tape or Decals to your clients nails. Then go on to step 10 as directed.